Whirlpool WSLT 65F AS X Návod k použití stáhnout pdf (Strana 7)

GB7

CLEANING

WARNING:

- Do not use steam cleaners.

- Disconnect the appliance from the power supply

IMPORTANT: Do not use corrosive or abrasive detergents. If any of these products accidentally comes into contact with the appliance, clean it

immediately with a damp cloth.

• Clean the surfaces with a damp cloth. If very dirty, add a few drops of washing up detergent to the water. Dry with a dry cloth.

IMPORTANT: Do not use abrasive sponges or metallic scrapers or scouring pads. Their use could eventually ruin the enamelled surfaces.

• Use specic detergents to clean the appliance and follow the manufacturer’s instructions

IMPORTANT: Clean the lters at least once a month to remove built-up oil and grease.

INSTALLATION - FITTING INSTRUCTIONS

Note: the elements marked with the symbol “(*)” are optional accessories supplied only with some models or elements to purchase, not supplied.

Extraction version installation (A): Fumes are extracted and expelled to the outside through an exhaust duct xed to the upper circular ange A1 (bayonet

coupling + screw fastening), remove the prescored metal panel and t the duct connector.

Filter version installation (F): If fumes and steam cannot be discharged to the outside, the hood can be used in lter version by tting a carbon lter/s (*);

fumes and steam are recycled through the front grille located above the control panel (do not remove the pre-scored metal panels!).

Check the position of the extraction/lter selector (inside the hood) G.

Wall xing - Place the hood against the wall (or use the template H, if provided) and mark the holes (3 or 4 Ø 8 mm holes) with a pencil, drill, insert the wall plugs J

in the holes and 2 screws K in the top holes, remove the grille and hook the hood on the 2 screws, then insert the third (and fourth) screw/s L from inside and tighten

all of them.

Fixing to wall unit - Position the hood (or use the template H, if provided) and, using a pencil, mark the 4 Ø 6 mm through holes to be made on the bottom of the

wall unit.

Fix the hood with 4 screws M from inside the wall unit.

DESCRIPTION AND USE OF THE HOOD

Control panel

Light: move the switch to the right or press the next button to switch on.

Extraction speed: Move the switch to the right or press the next button to increase extraction speed.

Note: You should open the visor N every time you switch on the hood in order to use it correctly.

Grease lter - can be one of the following types:

Paper lter: to be replaced once a month or, if the top part is coloured, when the colour shows through the holes in the grille.

Metal lter: to be washed once a month by hand or in a dishwasher with quick wash cycle at low temperature.

To access the grease lters open the grille by means of the releases E1 and free it from the retainers R1.

The carbon lter (*) must be changed once a month.