Whirlpool RCH3660 Uživatelský manuál stáhnout pdf

VENTED KITCHEN SHELF HOOD

FOR 120 V. OPERATION

AVhiTlDool

IMPORTANT

FOR VENTLESS INSTALLATION, DIS

REGARD THIS INSTRUCTION SHEET.

USE VENTLESS KIT INSTRUCTION

SHEET FOR MODEL RCH3660.

KITCHEN

RANGE HOOD

MODEL

RH3330XL-1

INSTALLATION INSTRUCTIONS

READ AND SAVE THESE INSTRUCTIONS

Before you begin, read the following instructions

completely and carefully. If followed, they will simplify

the installation job.

’ ^ORTANT: OBSERVE ALL GOVERNING CODES

AND ORDINANCES

SAVE THESE INSTRUCTIONS FOR THE LOCAL

ELECTRICAL INSPECTOR’S USE

FOR USE WITH WHIRLPOOL “J ” AND

LINE MICROWAVE OVENS

FOR USE OVER WHIRLPOOL CONVENTIONAL

GAS AND ELECTRIC RANGE COOKTOPS

THAT DO NOT HAVE A GRILLE.

BEFORE YOU USE YOUR SHELF HOOD:

Be sure your shelf hood is installed on an appropriate wall

strong enough to support this appliance.

NOTE: The shelf hood is designed to support a microwave

oven with a net weight of up to 75 pounds, plus approved

accessories, cookbooks, utensils, and food.

The area used for the installation must be suitable for the

size, function, and protection (from elements) of the shelf

hood.

WARNING: THE WEIGHT OF THE MICROWAVE MAY

EXCEED YOUR LIFTING ABILITY. WE RECOMMEND

ASSISTANCE.

CAUTION: When mounting the shelf hood to a wall, you

must locate 2 studs in the wail. Do not attempt to install the

hood if the 2 wall studs are not found.

Be careful when drilling holes into a wall. Electrical wires and

water pipes may be concealed behind the wall covering.

/gg^/Tf

TOOLS AND MATERIALS REQUIRED

• Drill, electric or ratchet drive, with 3/8", 3/16” and 1/8"

wood bit (for drilling starter holes) and 1-1/4" wood bit

(to drill an access hole in the cabinet or kitchen wall for

the electric power line.)

• One common and one phillips head screwdriver (to

secure hood mounting screws to the cabinet and hood

sheet metal parts).

• Pliers (for opening knockouts).

• Pencil, ruler and level for marking cabinet locations.

• Sabersaworkeyhoiesawforcuttingthewall or cabinet

openings.

• Caulking, metal snips, duct tape, ducts (with elbow and

transition, if necessary) and wall cap or roof cap, as

required.

Page 1

5-22-85

1 2 3 4 5 6

Shrnutí obsahu

Strany 1 - INSTALLATION INSTRUCTIONS

VENTED KITCHEN SHELF HOOD FOR 120 V. OPERATIONAVhiTlDoolIMPORTANTFOR VENTLESS INSTALLATION, DISREGARD THIS INSTRUCTION SHEET. USE VENTLESS

Strany 2 - VENTING REQUIREMENTS

INSTALLATIONREQUIREMENTSA. Space RequirementsA typical installation can be seen in Figure 1. Study Figure 1 before proceeding. The shelf hood require

Strany 3 - ' FOR ANCHOR BOLT

CAUTION: If two studs are not located on the line drawn (Figure 5), DO NOT attempt to instail the hood.NOTE: if the shelf hood is to

Strany 4 - PROVIDING ELECTRICAL

FRONT PANEL REMOVAL1. Remove the three screws that secure the front panel; lower and remove front panel.2. This appliance is equipped wi

Strany 5 - "OOD

FILTER REMOVAL AND INSTALLATIONThe aluminum filter is held in place with the two filter clips located on the front panel. (See illustrations belo

Strany 6 - SIDE PANEL INSTALLATION

SIDE PANEL INSTALLATIONThe side panels can be used to fill the space left on a 30" shelf hood when the microwave oven is centered on the hood.Loc

Komentáře k této Příručce

Žádné komentáře

Whirlpool RCH3660 Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Větráky Whirlpool RCH3660. Whirlpool RCH3660 User Manual Uživatelská příručka

Shrnutí obsahu

Komentáře k této Příručce

Související produkty a manuály pro Větráky Whirlpool RCH3660