Whirlpool ACM 992 IX Návod k použití stáhnout pdf (Strana 20)

Gas adjustments

The hose must be connected as shown in Fig. 1 and 2, in

compliance with the local regulations.

Natural gas

Use outlet union GN for natural gas.

The hose must be connected to the outlet union and secured

using hose clamp B (Fig. 1). A mechanical connection can also

be used where appropriate. To make this connection, remove

the NG nut from the tip of the manifold. Place the extra seal that

is placed in the injector set on the connector to the appliance,

and then assemble the connector to the appliance. The

connector to the appliance must be ½” threaded female.

Butane/Propane gas

Use outlet connector B/P for Butane/Propane gas. The hose

must be connected to the outlet union and secured using hose

clamp B (Fig. 2).

The hose must not be longer than 2 m. It must be a standard

hose and replaced within the date printed on it.

Important: Close the gas supply cock before carrying out any

maintenance operation.

Connection details: see the specific regulations for your

country.

Use pressure regulators that are suitable for the gas

pressure values given on the Product Description Sheet

supplied separately.

If the appliance is arranged for a type of gas different from that

available, it is necessary to change the injectors, adjust the

minimum flame and change the outlet union.

Carry out the following operations to change the hob injectors:

remove the pan supports, remove the burners and burner caps

(see Fig. 3); change the injector (Fig. 4) and replace it with one

suitable for the new type of gas (see table on the separate

Product Sheet). Replace the gas setting label with the new

one included in the injector bag.

Refit everything by proceeding in reverse order, making sure to

correctly fit the burner cap on the burner.

Minimum for hob taps

NB: The appliance injectors must be replaced by an

authorised technician.

For appliances equipped with Flame Failure Devices and

microswitches, the control panel must be removed in order to

safely access the adjusting screw.

To adjust the minimum flame, proceed as follows

• Light the burner and turn the knob to min. ; remove the

tap knob (Fig. 5). Insert a small screwdriver in the tap pin

(Fig. 6).

Turn the adjustment screw anticlockwise to increase the flame,

or clockwise to decrease it. Adjustment is correct when the

flame is approx. 3 - 4 mm.

The adjustment screw must be completely screwed down for

butane/propane gas.

Make sure the flame does not go out when switching straight

from high to low flame and vice versa.

Refit the knob.

Fig. 3

Fig. 4

Fig. 1 Fig. 2

Fig. 5

Fig. 6

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 62 63

Komentáře k této Příručce

Žádné komentáře

Whirlpool ACM 992 IX Návod k použití Strana 20

Komentáře k této Příručce

Související produkty a manuály pro Sporáky Whirlpool ACM 992 IX