Whirlpool AKM281/IX Návod k použití stáhnout pdf (Strana 7)

INSTALLATION

OVEN/COOKTOP DIRECT GAS CONNECTION

(please refer carefully to the separate oven instructions

for use)

Slacken the screws

(A)

off and position the cooktop in such

a way that the taps are aligned with the oven knobs.

Adjust the height of the tap bracket

(C)

according to the

position (2,3,4,5) indicated on the brackets

(D)

. Once

adjusted to the correct height, tighten the screws

(A)

Use the screws

(B)

provided, to secure the cooktop taps

bracket

(C)

to the oven panel. Fit the knobs.

ADJUSTMENT TO DIFFERENT TYPES OF GAS

If a different type of gas to the type shown on the rating plate and

on the orange sticker affixed to the top of the cooktop is used, the

cooktop must be converted to work with the new gas type.

Remove the orange sticker and affix it to the instructions booklet,

which must be retained for the lifetime of the appliance.

Use pressure regulators suitable for the gas pressures

indicated in the separate Product Description Sheet.

The gas nozzles must be changed by After Sales Service or a

qualified technician. Nozzles not supplied with the appliance

must be ordered from After Sales Service.

Connect the cooktop to the gas shut-off valve by means of a

pipe suitable for the type of gas used, in compliance with

current local regulations.

Adjust the minimum setting of the taps.

Note:

when liquid petroleum gas is used (G30/G31), the

minimum gas setting screws must be fully tightened.

Replacing the injectors

(see table in the separate Product

Description Sheet)

Remove grids

(A)

Extract burners

(B)

Using a socket spanner of the appropriate size (7)

(C)

unscrew the injector to be replaced.

Replace it with the injector suitable for the new type of gas.

Re-assemble the injector in

(D)

Adjusting minimum gas setting of taps

To ensure that the minimum setting is correctly adjusted,

remove knob and proceed as follows:

•

tighten (-) to reduce the height of the flame;

•

loosen (+) to increase the height of the flame;

The adjustment must be performed with the tap in minimum gas

setting position (small flame) .

Upon completion of adjustment, reseal using sealing wax or an

equivalent material.

The primary air of the burners does not need to be adjusted.

After the adjustment of the minimum gas setting, light up the

burners and turn the knobs from max. position to min.

position to check the stability of the flame.

6gb61801b.fm5 Page 17 Friday, April 11, 2003 2:44 PM

1 2 3 4 5 6 7

Komentáře k této Příručce

Žádné komentáře

Whirlpool AKM281/IX Návod k použití Strana 7

Komentáře k této Příručce

Související produkty a manuály pro Sporáky Whirlpool AKM281/IX