Whirlpool CLHB 31/NE Návod k použití stáhnout pdf (Strana 8)

GB6

After unpacking the product, check for any damage during transport. In case of problems, contact the dealer or the After-

Sales Service.

For built-in dimensions and installation instruction, see the pictures in page 2.

PREPARING THE CABINET FOR FITTING

Connection to the terminal block

For the electrical connection, use an H05RR-F cable as specified in the table below.

Important:

- Based on the wiring diagram (see figure) either keep or remove the metal jumpers between the screws on the terminal

block L1-L2 and N1-N2.

- If the cable is provided, see the connection instructions attached to the cable.

- Make sure all six screws on the terminal block are tightened after connecting the cables.

INSTALLATION

WARNING

- Install a separator panel

under the hob.

-The lower part of the

product must not be

accessible after

installation.

- Do not fit the separator

panel if an undertop oven

is installed.

• The distance between the underside of the appliance and the separator panel must respect the dimensions given

in the figure.

• In order to ensure the correct operation of the product, do not obstruct the minimum required clearance between

the hob and the top of the unit (min. 5 mm).

• If an undertop oven is installed, make sure the oven is equipped with a cooling system.

• Do not install the hob above a dishwasher or washing-machine, so that the electronic circuits do not come into

contact with steam or moisture which could damage them.

• In the case of flush-mounted installation, call the After-Sales Service to request assembly of screws kit 4801 211 00112.

• To remove the hob, use a screwdriver (not provided) to prise off the perimeter clips on the underside of the appliance.

ELECTRICAL CONNECTION

WARNING

- Disconnect the appliance from the power supply.

- Installation must be carried out by qualified personnel who know the current

safety and installation regulations.

- The manufacturer declines all liability for injury to persons or animals and for damage to property resulting from

failure to observe the regulations provided in this chapter.

- The power cable must be long enough to allow the hob to be removed from the worktop.

- Make sure the voltage specified on the dataplate located on the bottom of the appliance is the same as that of

the home.

Wires Number x size

230 V ~ +

3 x 4 mm

230-240 V ~ +

3 X 4 mm

(Australia only)

230 V 3 ~ +

4 x 1.5 mm

400 V 3N ~ +

5 x 1.5 mm

400 V 2N ~ +

4 x 1.5 mm

min. 5 mm

min. 20 mm

min. 5 mm

400 V 3N ~ 230 V ~

230-240 V ~ (Australia only)

230 V ~ (UK only)

400 V 2N ~ 230 V 3 ~ (Belgium only) 400 V 2N ~ (Holland only)

230 V

CBA

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Komentáře k této Příručce

Žádné komentáře

Whirlpool CLHB 31/NE Návod k použití Strana 8

Komentáře k této Příručce

Související produkty a manuály pro Sporáky Whirlpool CLHB 31/NE