Whirlpool DBHVS 81 LT K Návod k použití stáhnout pdf (Strana 11)

EN11

DBHVS 81 LT K

T1 T2 T3 T4 T5 T6

T1. Motor ON/OFF button (stand by) – resets the lter saturation indicators

T2. ON button – speed selection (extraction power) for low speed

T3. Speed selection button (extraction power) for normal speed

T4. Speed selection button (extraction power) for high speed and Intensive setting.

Press to activate high speed (extraction power).

Press again to activate the Intensive speed setting (extraction power) (button ashes for 5 minutes, after which it returns to normal speed (extraction power).

T5. “Anti-condensation function” ON/OFF button: Prevents condensation from forming on the surface of the hood. Activate as required.

“Automatic anti-condensation function”: The hood activates this function each time the hood is switched on.

Automatic ON/OFF activation: With the hood switched o, press and hold the button (for around 3 seconds until a “beep” signal sounds) to activate or

deactivate this function.

Please note: The anti-condensation function must only be activated when the motor is switched on.

Warning! Even if this function is never activated, carry out periodic maintenance of the condensation pan all the same, as indicated in the

“Maintenance – Cleaning – Maintenance of the condensation pan” section.

T6. Light ON/OFF button.

Filter saturation indicators

At regular intervals, the hood signals the need to perform lter maintenance.

Please note: The indicators are activated when the hood is switched on.

Flashing T2 button: Carry out maintenance on the grease lter.

Flashing T3 button: Carry out maintenance of the active carbon lter.

Please note: The lter saturation signal is visible within the rst minute after the hood has been switched o; after this time, the saturation indicators are reset.

Filter saturation indicator reset:

Please note: This action is carried out with the hood switched on.

Press and hold the T1 button.

Active carbon lter saturation indicator activated

Please note: This action is carried out with the hood switched o.

This indicator is usually deactivated; simultaneously press and hold the T2 and T3 buttons to activate the function: The T3 button lights up to indicate activation.

To deactivate the function, simultaneously press and hold the T2 and T3 buttons: The T3 button ashes briey and then goes out to indicate deactivation.