Whirlpool ESDF 6040 FS Návod k použití stáhnout pdf (Strana 11)

Step Control panel Display

The display shows

3 The light comes on together with

the in-use lights for the individual cooking zones

The display shows the set level which ashes

for approximately 2 seconds; after which the hob

emits an acoustic signal and then turns itself o;

it is now ready for use

Press for approximately

3 seconds

Press the Power

Management button to

conrm the previous step

Press to set the chosen

level amongst the dierent

options available

Press the Power

Management button

to conrm the previous step

In case of an error when setting the power, the symbol appears in the middle and an acoustic signal sounds for about 5 seconds. In this case repeat

the conguration procedure from the beginning. If the error occurs again, contact the After-Sales Service. During normal use, if the user tries to increase the

maximum available power level when reached, the level of the zone in use ashes twice and an acoustic signal sounds. To obtain a higher power in that zone,

it is necessary to manually decrease the power level of one or more already active cooking zones.

Activation/deactivation of the acoustic signal

After switching the hob on, press and hold the “+” button and the outermost button on the right simultaneously for at least ve seconds (“control panel lock”).

5 sec.

CLEANING

-Do not use steam cleaners.

-Before cleaning, make sure the cooking zones are switched off and that the residual heat indicator (“H”)

is not displayed.

If your glass has the iXelium

logo, your hob is equipped with iXelium

treatment. iXelium

is the exclusive Whirlpool nishing that guarantees a perfect

clean and a long-lasting brilliance. Therefore, if you have a IXELIUM hob, we strongly suggest to observe the following cleaning recommendations:

• Use a soft cloth (microbre is best) dampened with water or with everyday glass cleaning detergent.

• If you want to enhance furtherly cleaning results, just let the glass in contact with a wet cloth for couple of minutes.

IMPORTANT: Do not use abrasive sponges or scouring pads. Their use could eventually ruin the glass.

• After each use, clean the hob (when it is cool) to remove any deposits and stains due to food residuals.

• Sugar or foods with a high sugar content damage the hob and must be immediately removed.

• Salt, sugar and sand could scratch the glass surface.

• Use a soft cloth, absorbent kitchen paper or a specic hob cleaner (follow the Manufacturer’s instructions).

• Liquid splillages on the cooking zones may make pan vibrate or move

• Dry the hob thoroughly after cleaning it.

TROUBLESHOOTING GUIDE

• Read and follow the instructions given in the section “Instructions for use”.

• Check that the electricity supply has not been shut off.

• Dry the hob thoroughly after cleaning it.

• If, when the hob is switched on, alphanumeric codes appear on the display, consult the following table for instructions.

• If the hob cannot be switched off after using it, disconnect it from the power supply.

WARNING

1 2 ... 6 7 8 9 10 11 12 13

Komentáře k této Příručce

Žádné komentáře

Whirlpool ESDF 6040 FS Návod k použití Strana 11

Komentáře k této Příručce

Související produkty a manuály pro Sporáky Whirlpool ESDF 6040 FS