Whirlpool KHID3 65510 Návod k použití Strana 11

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 20
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 10
11
Installation
After unpacking the product, check for any damage during transport.
In case of problems, contact the dealer or the After-Sales Service.
For built-in dimensions and installation instruction, see the pictures in page 5.
PREPARING THE CABINET FOR FITTING
WARNING
- Install a separator panel under the hob.
- The lower part of the product must not be accessible after installation.
- Do not t the separator panel if an undertop oven is installed.
The distance between the underside of the appliance and the separator
panel must conform to the dimensions given in the gure.
In order to ensure correct operation of the product, do not obstruct the
minimum required clearance between the hob and the top of the unit
(min. 5 mm).
If an undertop oven is installed, ensure that the oven is equipped with a
cooling system.
Do not install the hob above a dishwasher or washing-machine, so that
the electronic circuits do not come into contact with steam or moisture which could damage them.
In the case of ush-mounted installation, call the After-Sales Service to request assembly of screws kit
4801 211 00112.
To remove the hob, use a screwdriver (not provided) to prise o the perimeter clips on the underside
of the appliance.
Electrical connection
WARNING
- Disconnect the appliance from the power supply.
- Installation must be carried out by qualied personnel who know the current safety and
installation regulations.
- The manufacturer shall not be held liable for injury to persons or animals, or for damage to
property resulting from failure to observe the regulations provided in this chapter.
- The power cable must be long enough to allow the hob to be removed from the worktop.
- Ensure that the voltage specied on the rating plate located on the bottom of the appliance is
the same as that of the home.
min 5 mm
min 20 mm
Zobrazit stránku 10
1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Komentáře k této Příručce

Žádné komentáře