Whirlpool BFG2J5040T3NOV E Příručka pro použití a péči

Procházejte online nebo si stáhněte Příručka pro použití a péči pro Ohřívače vody a bojlery Whirlpool BFG2J5040T3NOV E. Whirlpool BFG2J5040T3NOV E Use & care guide Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 29
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
1
R
Made under license from Flame Guard Water Heaters, Inc.
Gas Water Heater
with the Flame Guard
®
Safety System
Installation
Instructions and
Use & Care Guide
Do not store or use gasoline or other
flammable vapors and liquids in the
vicinity of this or any other appliance.
WHAT TO DO IF YOU SMELL GAS
Do not try to light any appliance.
Do not touch any electrical switch;
do not use any phone in your
building.
Immediately call your gas supplier
from a neighbors phone. Follow
the gas suppliers instructions.
If you cannot reach your gas
supplier, call the fire department.
Installation and service must be performed
by a qualified installer, service agency or
the gas supplier.
WARNING: If the information in these
instructions is not followed exactly, a fire
or explosion may result causing property
damage, personal injury or death.
INSTALLER:
AFFIX THESE INSTRUCTIONS TO OR ADJACENT
TO THE WATER HEATER.
OWNER:
RETAIN THESE INSTRUCTIONS AND WARRANTY
FOR FUTURE REFERENCE. RETAIN THE ORIGINAL
RECEIPT AS PROOF OF PURCHASE.
To obtain technical, warranty, or service assistance during or after
the installation of this water heater, visit our website at:
http://www.americanwaterheater.com
or call toll free
1-800-999-9515
When calling for assistance, please have the following
information ready:
1. Model number
2. 7 digit product number
3. Serial number
4. Date of installation
5. Place of purchase
Table of Contents ...................................................... 2
6510366
December 2005
NATURAL GAS MODELS ONLY
Zobrazit stránku 0
1 2 3 4 5 6 ... 28 29

Shrnutí obsahu

Strany 1 - Use & Care Guide

1RMade under license from Flame Guard Water Heaters, Inc.Gas Water Heaterwith the Flame Guard® Safety SystemInstallationInstructions andUse & Care

Strany 2 - Table Of Contents

10Vent Pipe SystemThis water heater uses a non-direct, single-pipe vent system to remove exhaust gases created by the burning of fossil fuels. Air for

Strany 3 - Unpacking the Water Heater

11Chimney ConnectionImportant: Before connecting a vent to a chimney, make sure the chimney passageway is clear and free of obstructions. The chimney

Strany 4 - Location Requirements

12Water System PipingPiping InstallationPiping, fittings, and valves should be installed according to the installation drawing (Figure 13). If the ind

Strany 5 - Clearances and Accessibility

13Please note the following: DO NOT install this water heater with iron piping. The system should be installed only with piping that is suitable for

Strany 6 - Gas Supply

14Temperature and Pressure Relief ValveExplosion HazardIf the temperature and pressure reliefvalve is dripping or leaking, have aqualified service tec

Strany 7 - Ventilation

15Special ApplicationsCombination Space Heating/Potable Water SystemSome water heater models are equipped with inlet/outlet tappings for use with spac

Strany 8 - Confined Space

16Installation ChecklistWater Heater Location□ Centrally located with the water piping system. Located as close to the gas piping and vent pipe syste

Strany 9 - Louvers and Grilles

17OPERATING YOUR WATER HEATERFOR YOUR SAFETY READ BEFORE LIGHTINGTO TURN OFF GAS TO APPLIANCEA. This appliance has a pilot which is lighted by apiezoe

Strany 10 - Vent Connectors

18Checking the DraftBurn HazardDo not touch vent.Doing so can result in burns.After successfully lighting the water heater, allow the unit to operate

Strany 11 - Vertical Exhaust Gas Vent

19Operational ConditionsCondensationMoisture from the products of combustion condenses on the tank surface and the outside jacket of the water heater

Strany 12 - Water System Piping

2Table Of ContentsWater Heater Safety ... 1-2Installing Your Gas Water Heat

Strany 13

20MAINTENANCE OF YOUR WATER HEATERDraining and FlushingIt is recommended that the tank be drained and flushed every 6 months to remove sediment which

Strany 14 - Relief Valve

21Replacement PartsThe following maintenance procedures are for the Flame Guard® Safety System components and should be performed by a qualified servi

Strany 15 - Special Applications

22Replacing the Thermocouple1. Remove the manifold assembly as directed previously.2. Remove the retainer clip from the back of the two piece wire c

Strany 16 - Your Water Heater

23Explosion HazardTighten both manifold door screwssecurely.Remove any fiberglass between the doorgasket and combustion chamber.Replace viewport if gl

Strany 17 - LIGHTING INSTRUCTIONS

24Flame Guard® Safety System Operational ChecklistTROUBLESHOOTING CHART5. No leaks at pilot and manifold connection.6. Manifold door screws securely

Strany 18 - Doing so can result in

25PROBLEM POSSIBLE CAUSE(S) CORRECTIVE ACTIONHIGH OPERATION COSTS 1. Thermostat set too high2. Sediment or lime in tank3. Water heater too small fo

Strany 19 - Operational Conditions

26PILOT LIGHT TROUBLESHOOTING CHART Has the thermal switch tripped?NOCheck for insufficient combustion air.Are there openings for make-up air to enter

Strany 20 - Maintenance

27REPAIR PARTS ILLUSTRATION8631245791011Anode location for side T & PAlternate anodelocation for topT & PItem No.Parts Description1 DRAFTHOOD2

Strany 21 - Replacement Parts

28Listed Parts Kits and IllustrationsItem 12: Pilot assembly kit, which contains the pilot assembly and retainer clip (Natural Gas) Item 13: Burner

Strany 22 - Flame-trap

Listed Parts Kits and IllustrationsItem 11: Pilot assembly/thermocouple kit, which contains the pilot assembly with piezoelectric igniter, thermocoupl

Strany 23 - Testing the Igniter System

3INSTALLING YOUR GAS WATER HEATERConsumer InformationThis water heater is design-certified by CSA International as a Category I, non-direct vented wat

Strany 24 - TROUBLESHOOTING CHART

4Location RequirementsThe Flame Guard® Safety System is designed to reduce the risk of flammable vapor-related fires. The patented system protects you

Strany 25

5Important: The water heater should be located in an area where leakage of the tank or connections will not result in damage to the area adjacent to

Strany 26 - Thermal

6Gas SupplyExplosion HazardUse a new CSA approved gas supply line.Install a shut-off valve.Do not connect a natural gas waterheater to an L.P. gas sup

Strany 27 - REPAIR PARTS ILLUSTRATION

7Nominal Iron Pipe Length of Pipe, FeetSize, in.1/23/411-1/41-1/21322785201050160092190350730110073152285590890631302455007605611521544067050105195400

Strany 28

8Unconfined SpaceA water heater in an unconfined space uses indoor air for combustion and requires at least 50 cubic feet for each 1,000 BTUH of the t

Strany 29

9Direct tooutdoorsVertical ductsHorizontal ductsFigure 6Figure 7Figure 8Table 3Minimum Free Area of Permanent Openings for Ventilation andCombustion A

Komentáře k této Příručce

Žádné komentáře