Whirlpool ACM 739/NE Instalační manuál stáhnout pdf (Strana 5)

GB15

Minute minder

The minute minder can only be used when the hob is not in use and allows a maximum setting of 99 min.

Press the button “+” below the timer indicators: the display shows the minutes for setting.

Select the time desired using the buttons + and -. After a few seconds the minute minder starts to count down.

Once the set time has elapsed an acoustic signal sounds.

IMPORTANT! The minute minder function can only be used when the hob is switched off; if it is then switched on, the minute minder countdown is automatically

cancelled.

Control panel indicators

Residual heat indicator

Incorrect or missing pot indicator.

IMPORTANT: do not use abrasive sponges or pan scourers as they could ruin the glass surface.

• Clean the hob, when it is cool, after each use in order to remove any food residues.

• Sugar and foods with a high sugar content damage the glass ceramic surface and must be immediately removed.

• Salt, sugar and sand can scratch the glass surface.

• Use a soft cloth, absorbent kitchen wipes or a specific hob cleaner (follow the Manufacturer’s instructions).

• Read and follow the instructions given in the section “Instructions for use”.

• Connect the hob to the electricity supply and check that the supply has not been shut off.

• Clean the hob and dry it thoroughly.

• If you are unable to turn the hob off after using it, disconnect it from the power supply.

• If, when the hob is switched on, alphanumeric codes appear on the display, consult the following table for instructions.

The hob is fitted with a residual heat indicator for each cooking zone. These indicators alert the user when cooking zones are still hot.

If the display shows “H”, the cooking zone is still hot. If the residual heat indicator of a given cooking zone is lit, that zone can be used, for example, to

keep a dish warm or to melt butter. When the cooking zone cools down, the display switches off.

The hob features an automatic pot detection system for all cooking zones. If no pot is detected, the display with the cooking zone power level indicator

flashes. Make sure the pot is correctly positioned and that it has the characteristics given in the section “Before use”.

CLEANING

WARNING

- Never use steam cleaners.

- Before cleaning, make sure the cooking zones are switched off and that the residual heat indicator (“H") is

not displayed.

TROUBLESHOOTING GUIDE

ERROR CODE DESCRIPTION POSSIBLE CAUSES REMEDY

The hob switches off and after 10 seconds

emits an acoustic signal every 30 seconds.

Continuous pressure on control panel

area.