Whirlpool ACM 935/1 WH Návod k použití stáhnout pdf (Strana 4)

Gas adjustments

Use pressure regulators that are suitable for the gas

pressure values indicated in the Product Description Sheet

supplied separately.

If the appliance is arranged for a type of gas different from that

available, it is necessary to change the injectors, adjust the

minimum flame, change the outlet connector.

Carry out the following operations to change the hob injectors:

remove the grills; remove the burners, the burner caps

(see Fig. 5); change the injector and replace it with one suitable

for the new type of gas (see table in separate Product Sheet).

Replace the gas calibration label with the new label included in the

injector bag.

Refit everything in reverse order, making sure to correctly fit the

burner cap on the burner.

Minimum for hob taps

To adjust the minimum flame, proceed as follows:

• Light the burner and turn the knob to minimum ; remove

the tap knob (Fig. 6). Insert a small screwdriver next to the tap

pin (Fig. 7).

Attention: in taps with security valve, the minimum adjusting

screws is placed outside the rod tap (fig. 7A).

Turn the adjustment screw anticlockwise to increase the flame,

or clockwise to decrease it. Adjustment is correct when the flame

is approx. 3 - 4 mm.

The adjustment screw must be completely screwed down for

butane/propane gas.

Make sure the flame does not go out when switching suddenly

from high to low flame and vice versa.

Refit the knob.

Fig. 6

Fig. 5

Fig. 7

Fig. 7A

1 2 3 4 5 6 7 8 9 ... 14 15

Žádné komentáře

Whirlpool ACM 935/1 WH Návod k použití Strana 4