Whirlpool ACM 935/1 WH Návod k použití stáhnout pdf (Strana 7)

Installation

Important: The covering of the cabinets must be in heat

resistant (min. 90°C) material.

If the appliance is installed next to kitchen cabinets, ensure the

minimum clearances indicated in the following figure 9.

There are certain points to pay attention to when positioning the

cooker. Make sure to take into consideration the following

recommendations, in order to prevent any problems and

hazardous situations that may occur!

The cooker can be positioned near other cabinets provided their

height does not exceed the hob level.

In selecting a position for the cooker, make sure the appliance is

not placed next to a refrigerator and that there are no flammable

or combustible materials in the vicinity, such as curtains, etc.

which can quickly catch fire.

A minimum space of 20 mm between the metal rear cover of the

cooker and the wall is required to ensure air circulation.

If the counter tops are higher than hob level, they should be at

least 110 mm from the sides of the cooker.

To fit them, tilt the appliance and screw the 4 feet in the special

threads located in the corners (see Fig. 10).

Adjust leveling Legs

If range height adjustment is necessary, manually adjust the

leveling leg sleeves to loosen the 4 leveling legs. Leveling legs can

be loosened to add uo to a maximum of 3.5 cm.

This may be done with the range on its back or with the range

supported on 2 legs after the range has been placed back to a

standing position.

NOTE: To place range back up to a standing position, put a sheet

of cardboard or hardboard in front of the range. Using 2 or more

people, stand range back up onto the cardboard or hardboard.

Fig. 9

Fig. 10

Levelling leg

sleeves

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Žádné komentáře

Whirlpool ACM 935/1 WH Návod k použití Strana 7