Whirlpool AKM 702/NB/02 Návod k použití stáhnout pdf (Strana 10)

INSTALLING THE HOB

The appliance must be connected to the supply using a

multipole switch with a minimum contact gap of 3 mm.

Important:

the power supply cable must be long enough to

allow the hob, even after connected, to be lifted out of the

worktop from above and turned over; the cable run must be

routed so as to avoid damage or overheating caused by contact

with the base.

Connection to the terminal board

Note:

the earthing wire (colour: yellow-green) must be

connected to the terminal marked with the symbol.

- Strip back the cable sheath (

) by about 70 mm.

- Strip approx. 10 mm of sheath from the conductors.

Insert the cable (

) through the opening in the cover (

- Insert the cable into the cable clamp and connect the

conductors to the terminal board as indicated in the diagram

printed on the cover.

- Secure the cable (

) in the corresponding cable clamp.

- Refit and secure the protective cover (

The electrical components must not be accessible after

installation.

The installer is responsible for correct electrical connection

of the appliance.

On completion of the electrical connection, fit the hob into the

worktop from the top and secure it by means of the clips as

shown.

1 2 ... 5 6 7 8 9 10 11

Žádné komentáře

Whirlpool AKM 702/NB/02 Návod k použití Strana 10