Whirlpool CP 649 MT (X) DK Návod k použití stáhnout pdf (Strana 22)

INSTALLATION

ELECTRICAL CONNECTION

Those ovens equipped with a three-pole power supply cable

are designed to operate with an alternating current with the

voltage and frequency indicated on the data plate (located on

the appliance) and in the instruction booklet. The wire for earth-

ing the appliance is yellow-green in colour.

Fitting on a power supply cable

Opening the terminal board:

• Using a screwdriver, prise on the side tabs of the terminal

board cover;

• Pull open the cover of the terminal board.

To install the cable, proceed as follows:

• Remove the wire clamp screw and the three contact screws

L-N-

• Fasten the wires beneath the screwheads using the follow-

ing colour scheme: Blue (N) Brown (L) Yellow-Green

• Secure the supply cable in place with the clamp and close

the cover of the terminal board.

Connecting the supply cable to the mains

Install a standardised plug corresponding to the load indicated

on the data plate. When connecting the cable directly to the

mains, install an omnipolar circuit-breaker with a minimum con-

tact opening of 3 mm between the appliance and the mains.

The omnipolar circuit breaker should be sized according to the

load and should comply with current regulations (the earth wire

should not be interrupted by the circuit breaker).

The supply cable must be in such a position that no part of it

can reach a temperature of 50°C above room temperature.

Before connecting to the power supply, make sure that:

• The electrical safety of this appliance can only be guaran-

teed if the cooker is correctly and efficiently earthed, in com-

pliance with regulations on electrical safety. Always ensure

that the earthing is efficient; if you have any doubts call in a

qualified technician to check the system. The manufacturer

denies all responsibility for damage resulting from a system

which has not been earthed.

• Before plugging the appliance into the mains, check that

the specifications indicated on the date plate (on the appli-

ance and/or packaging) correspond to those of the electri-

cal and gas mains of your home.

• Check that the electrical capacity of the system and sock-

ets will support the maximum power of the appliance, as

indicated on the data plate. If in doubt, consult a qualified

technical engineer.

• If the socket and appliance plug are not compatible, have

the socket replaced with a suitable model by a qualified

technical engineer. The latter, in particular, will also have to

ensure that the cross section of the socket cables are suit-

able for the power absorbed by the appliance. The use of

adapters, multiple sockets and/or extensions, is not recom-

mended. If their use cannot be avoided, remember to use

only single or multiple adapters and extensions which com-

ply with current safety regulations. In these cases, never

exceed the maximum current capacity indicated on the sin-

gle adapter or extension and the maximum power indicated

on the multiple adapter. The plug and socket must be

easily accessible.

1 2 ... 17 18 19 20 21 22 23 24

Komentáře k této Příručce

Žádné komentáře

Whirlpool CP 649 MT (X) DK Návod k použití Strana 22

Komentáře k této Příručce

Související produkty a manuály pro Sporáky Whirlpool CP 649 MT (X) DK