
315222
maximum of 10 mm, until the glass support wedge slips out of
the groove (Figure 1).
• Remove the glass (in the direction of arrow 3).
• Interior glass (only in some models) is removed by fi rst
undoing the screws on the glass supports and then by lifting
it (Figure 2). Remove the supports before cleaning the glass
pane.
• Reinstall the door by following the same procedure in reverse
order.
Note: Insert the glass into the slot and push it forward (Figure 3).
Removing and replacing the oven door with a cam hinge
• Completely open the oven door. Lift the clips of the lower
hinge supports on both sides to the upright position and clip
them to the plug of the upper hinge supports.
• Close the oven door half way and gently pull them out.
Replace the door in the reverse order.
• Insert the door in the half-closed position (angle of
approximately 60°) by pushing them towards the oven while
opening them all the way. Pay attention to the notches on
the lower hinge supports, which should coincide with the
lower edge of the notches on the front side. When the door
is completely opened, remove the clips from the plugs of the
upper hinge supports and return them to horizontal position.
Removing and inserting the oven door with a single-axis
hinge
Completely open the oven door and rotate the attachment clips
completely backwards (Figure 1).
• Slowly close the door until the clips are pressed against the
supports / seats. At approximately 15° (relative to the closed
door position), pull the door slightly upward and pull them out
of the both hinge supports on the appliances (Figure 2).
• Replace the door in the reverse order. Insert the door under
an angle of 15° into the hinge supports at the front side of the
appliance and push them downwards and to the front until they
fi gure 2
fi gure 3
fi gure 2
fi gure 3
fi gure 1fi gure 1
36
Komentáře k této Příručce