Whirlpool SIM571B Návod k použití stáhnout pdf (Strana 8)

EN16

IMPORTANT: for the diameter of pot bottoms on zones which can be used with the “Auto-boiling” function, see paragraph “Auto-boiling”.

After unpacking the hob, check that there has been no damage during transport. If in doubt, contact the dealer or After-sales Service.

PREPARING THE HOUSING UNIT

RECOMMENDED DIAMETERS OF POT BOTTOMS

INSTALLATION

WARNING

- Install a separator panel under the

hob.

- The lower part of the product must

not be accessible after installation.

- If there is an oven beneath the hob,

do not install the separator panel.

• For the distance between the underside of the appliance and the separator panel below, observe the dimensions given in the figure.

• In order to ensure the correct operation of the product, do not obstruct the minimum required clearance between the hob and the top of the unit (min. 5 mm).

• Cut the worktop to fit before installing the hob and carefully remove any shavings or sawdust.

• If an oven is installed beneath the hob, make sure that it is equipped with a cooling system.

• To remove the hob from the worktop use a screw driver (not supplied) unlocking the springs from the bottom side of the appliance.

• Do not install the hob above a dishwasher or washing machine, to prevent the electronic circuits from coming into contact with steam or moisture and being damaged

as a result.

30 cm

24 cm

18 cm

14 cm

17 cm

14 cm

30 cm

24 cm

18 cm

28 cm

21 cm