Whirlpool AKM 260/IX Návod k použití stáhnout pdf (Strana 5)

INSTALLATION

Technical information for installer

This cooking hob can be embedded in a worktop 20 to 50

mm thick. If there is no oven beneath the cooktop (any oven

installed must be manufactured by us and equipped with a

cooling system), insert a separator panel at a minimum

distance of 20 mm from the bottom of the cooktop.

Note: before installation, make sure that the local gas

delivery conditions (nature and pressure of gas) are

compatible with the settings of the cooking hob, as

indicated on the rating plate.

 If a vertical piece of furniture is installed, there must be

a gap of at least 100 mm between it and the edge of the

cooking hob.



Before installing the cooking hob, remove the plastic film

that protects it, if present.

The outer surfaces of the furniture or appliances adjoining

the cooking hob must be heat resistant (heat protection 

)

according to standards.



Installation must comply with current local regulations.



In the room where the cooking hob is installed, there must

be enough air to allow the gas to burn correctly

(see relevant table).



The natural flow of air must take place through an adequate

opening, that must be:

- permanent, made on one of the outside walls of the room,

and communicating with the exterior in an area away from

sources of pollution;

- built so as to ensure that its openings, both on the inside

and on the outside, cannot be obstructed, intentionally or

accidentally;

- protected by a metal grid or mesh that does not reduce its

working section;

- situated near the floor level and positioned so as not to

interfere with the operation of the fume exhaust devices.

Assembly

 Apply the supplied gasket to the cooking hob (unless it

has already been fitted), after having cleaned its surface

as shown in the relevant figure.

To fasten the cooking hob, use brackets 

 supplied with it.

Fit the brackets into the relevant bores and fasten them by

means of their screws.

Make an opening in the worktop, respecting the dimensions

indicated in the enclosed product description sheet.

Install the cooking hob in the worktop.

Important: the power supply cable and plug must be

suitable for the power absorption of the cooking hob, and

the cable must be long enough to permit the upward

extraction of the cooking hob.

3gb53211.fm5 Page 16 Monday, June 3, 2002 6:33 PM

1 2 3 4 5 6 7

Komentáře k této Příručce

Žádné komentáře

Whirlpool AKM 260/IX Návod k použití Strana 5

Komentáře k této Příručce

Související produkty a manuály pro Sporáky Whirlpool AKM 260/IX