Whirlpool TGV 3570 IN Návod k použití Strana 3

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 8
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 2
14
Installation - Technical information for the Installer
Electrical connection
Assembly
The installation of the
cooktop must be carried
out without grids to
avoid any deformation
of the appliance.
Position the brackets
into the relevant holes
and tighten by means of
the screws supplied.
Make an opening in the
worktop, respecting the
dimensions indicated in
the separate Product
Description Sheet.
Apply the gasket
supplied along the
outer perimeter of the
worktop, as shown in
the figure. Also make
sure that the ends of the
gasket get in touch with
each other without
overlapping.
Install the cooktop into
the worktop.
Important
The power supply cable and
plug must be suitable for the
power absorption of the
cooktop and that cable must
be long enough to permit the
upward extraction of the
cooktop.
Installation must be carried
out in compliance with the
regulations of the local
electricity supply company.
Make sure that the voltage
indicated on the rating plate
corresponds to the voltage in
your home.
Regulations
require that the appliance
is earthed
: use conductors
(including the earth
conductor) of the appropriate
size only. The manufacturer
declines all responsibility for
injury to persons or animals
and for damage to property
resulting from failure to
observe the above
regulations.
The appliance must be
connected to the
electricity supply by
means of an all-pole
disconnect switch with
minimum contact gap of
3 mm.
If necessary, the electrical
power cable must be replaced
exclusively with a power cable
having identical
characteristics to the original
supplied by the manufacturer.
This operation must be
performed by the After Sales
Service or a qualified
electrician.
Warning
: The power supply
cable must be long enough to
allow the cooktop to be
removed from the worktop
and must be positioned so as
to avoid damage or
overheating caused by
contact with the base.
560
120 Min.
55
480
20mm Max
45mm Max
4gb66001.fm5 Page 14 Wednesday, January 9, 2002 10:25 AM
Zobrazit stránku 2
1 2 3 4 5 6 7 8

Komentáře k této Příručce

Žádné komentáře