Whirlpool TGV 3570 IN Návod k použití stáhnout pdf (Strana 4)

15

Connection to gas supply

 The gas supply system

must comply with local

regulations.

 The connection of the

cooktop to the gas pipe

network or gas cylinder

must be bade by means of

a rigid copper or steel pipe

with fittings complying

with local regulations.

The max. length of the

hose is 2 m.

Important

If a stainless steel hose is used,

it must be installed so as not

to touch any movable part of

the furniture. It must pass

through an area where there

are no obstructions and

where it is possible to inspect

it on all its length.

Adjustment to

different types of gas

 If a different type of gas

from the one indicated in

the rating plate is used,

the cooktop must be

adapted to it, proceeding

as follows:

 Replace the injectors with

the suitable ones for the

gas used (see the separate

Product Description

Sheet).

 Adjust the minimum

settings of the taps.

Adjustment of

minimum setting

After replacing the injectors,

light the burner and remove

the knob. Turn the tap to the

minimum setting and insert a

screwdriver in the rod:

tighten to reduce the flame,

loosen to increase the flame.

For gas G30/G31, tighten

the adjustment screw

fully.

The flame must be small,

uniform and regular all

around the burner crown.

Finally, check that the flame

does not go out by rapidly

turning the tap from the

maximum setting to the

minimum. For burners with a

safety device, check that the

flame slightly licks the

thermocouple. Make sure

that the adjustment is correct

by leaving the burner alight

for a few minutes. If it goes

out, increase the minimum

setting.

4gb66001.fm5 Page 15 Wednesday, January 9, 2002 10:25 AM

1 2 3 4 5 6 7 8

Komentáře k této Příručce

Žádné komentáře